Enabling And Disabling Parksense; Service The Parksense Rear Park Assist System - Dodge RAM TRUCK 15002017 Owner's Manual

Enabling And Disabling ParkSense

ParkSense can be enabled and disabled with the ParkSense
switch.
When the ParkSense switch is pushed to disable
the system, the instrument cluster display will
show the "PARKSENSE OFF" message for ap-
proximately five seconds. Refer to "Instrument
Cluster Display" in "Understanding Your Instrument
Panel" for further information. When the gear selector is
moved to REVERSE and the system is disabled, the instru-
ment cluster display will show the "PARKSENSE OFF"
message for as long as the vehicle is in REVERSE.
NOTE: The ParkSense system will automatically disable
when the system detects that a trailer with trailer brakes
has been connected to the Integrated Trailer Brake Module.
The instrument cluster
"PARKSENSE OFF" message for as long as the vehicle is in
reverse.
The ParkSense switch LED will be on when ParkSense is
disabled or defective. The ParkSense switch LED will be off
when the system is enabled.
display will show the
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 157
If the ParkSense switch is pushed, and the system is
disabled or requires service, the ParkSense switch LED will
blink momentarily, and then the LED will be on.

Service The ParkSense Rear Park Assist System

During vehicle start up, when the ParkSense Rear Park
Assist System has detected a faulted condition, the instru-
ment cluster display will actuate a single chime, once per
ignition cycle, and it will show the PARKSENSE UN-
AVAILABLE WIPE REAR SENSORS or the PARKSENSE
UNAVAILABLE SERVICE REQUIRED message. Refer to
"Instrument Cluster Display" in "Understanding Your
Instrument Panel" for further information. When the gear
selector is moved to REVERSE and the system has detected
a faulted condition, the instrument cluster display will
show the PARKSENSE UNAVAILABLE WIPE REAR SEN-
SORS or the PARKSENSE UNAVAILABLE SERVICE RE-
QUIRED message for as long as the vehicle is in RE-
VERSE. Under this condition, ParkSense will not operate.
If PARKSENSE UNAVAILABLE WIPE REAR SENSORS
appears in the instrument cluster display make sure the
outer surface and the underside of the rear fascia/bumper
is clean and clear of snow, ice, mud, dirt or other obstruc-
tion, and then cycle the ignition. If the message continues
to appear, see an authorized dealer.
3