Advertisement
Quick Links
FSA20-67-DIN
ASSEMBLY INSTRUCTIONS
Before assembling your antenna please confirm all the components below are included in the kit.
SCREEN CENTRE
LARGE CLAMP PLATE
INS-40101-8
M-8562
QTY: 1
QTY: 4
www.bird-technologies.com
0A-20-67-DIN
DIPOLE ASSEMBLY
QTY: 1
M12 HEX NUT
M12 SPRING WASHER
M12 FLAT WASHER
M12x250 THREADED ROD
M12 STUD ASSEMBLY
QTY: 4
©RF Industries Pty Ltd 2009
406-512 MHz
PAGE 1 OF 4
Advertisement
Related Manuals for RFI FSA20-67-DIN
Summary of Contents for RFI FSA20-67-DIN
- Page 1 406-512 MHz FSA20-67-DIN ASSEMBLY INSTRUCTIONS Before assembling your antenna please confirm all the components below are included in the kit. 0A-20-67-DIN DIPOLE ASSEMBLY M-8562 QTY: 1 SCREEN CENTRE QTY: 1 M12 HEX NUT M12 SPRING WASHER M12 FLAT WASHER M12x250 THREADED ROD...
-
Page 2: Antenna Assembly
406-512 MHz FSA20-67-DIN ANTENNA ASSEMBLY STEP 1: ASSEMBLE THE DIPOLE TO THE SCREEN AS DEPICTED BELOW USING 2 OF THE 4 LARGE CLAMP PLATES AND THE 4 M12 STUD ASSEMBLIES INCLUDED IN THE KIT. TIGHTEN THE M12 NUTS TO 55Nm (40 lbf.ft). LEAVE APPROXIMATELY 190mm PROTRUDING OUT THE BACK SIDE. -
Page 3: Assembly Instructions
406-512 MHz FSA20-67-DIN ASSEMBLY INSTRUCTIONS continued STEP 2: WITH THE ANTENNA ASSEMBLY LOCATED ON THE MOUNTING TUBE ATTACH THE REMAINING 2 LARGE CLAMP PLATES AND TIGHTEN THE M12 NUTS CLAMPING THE ANTENNA ASSEMBLY TO THE MOUNTING TUBE. TIGHTEN TO 55Nm (40 lbf.ft) - Page 4 406-512 MHz FSA20-67-DIN ASSEMBLY INSTRUCTIONS continued TYPICAL INSTALLATION SCREENED ARRAY ASSEMBLY THESE ITEMS FSA-20-41-DIN NOT INCLUDED IN ANTENNA KIT: OUTRIGGER TOWER CLAMPS TOWER MOUNT POLE STRAIN RELIEVE FEED CABLE BACK TO SUPPORT STRUCTURE. SEAL CONNECTOR WITH A SUITABLE SELF AMALGAMATING TAPE.