Scrolling Help Text In Display Line 3 - PR 4104 Manual

ScRolling HElP TExT in DiSPlay linE 3

[01] Set correct password
[02] Enter advanced setup menu?
[03] Select current input
Select voltage input
[04] Select 0..20 mA input range
Select 4..20 mA input range
Select -10..10 mA input range
Select -20..20 mA input range
[05] Select 0.0..1 V input range
Select 0.2..1 V input range
Select 0..5 V input range
Select 1..5 V input range
Select 0..10 V input range
Select 2..10 V input range
Select -1..1 V input range
Select -5..5 V input range
Select -10..10 V input range
[06] Select display unit
[07] Select decimal point position
[08] Set display range low
[09] Set display range high
[10] Select current as analog output type
Select voltage as analog output type
[11] Select 0...20 mA output range
Select 4...20 mA output range
Select 4...20 mA with safety readback
Select -10...10 mA output range
Select -20...20 mA output range
[12] Select 0.0...1 V output range
Select 0.2...1 V output range
Select 0...5 V output range
Select 1...5 V output range
Select 0...10 V output range
Select 2...10 V output range
Select -1...1 V output range
Select -5...5 V output range
Select -10...10 V output range
[13] Select active output mode
Select passive output mode
[14] Select no error action - output undefined at error
Select downscale at error
Select zero output at error
Select upscale at error
[15] Set Analog output response time in seconds
[16] Select Analog output function
Enter Language setup
Enter Password setup
Enter Simulation mode
Perform Process calibration
Enter Display setup
Perform Memory operations
[17] Load saved configuration into module
Save configuration in display front
[18] Adjust LCD contrast
[19] Adjust LCD backlight
[20] Write a 6-character device TAG
[21] Analog output value is shown in display line 3
Device TAG is shown in display line 3
[22] Calibrate Input low to process value?
[23] Set value for low calibration point
[24] Calibrate Input high to process value?
[25] Set value for high calibration point
[26] Use process calibration values
[27] Enable simulation mode?
[28] Set the input simulation value
[29] Enable password protection?
[30] Set new password
[31] Select language
[32] Select direct output mode
Select inverted output mode
Select V-function output mode
[33] Display underrange
[34] Display overrange
[35] Input underrange
[36] Input overrange
[37] Analog output supply error
[38] Analog output error
- check output connections and reset power
[39] Configuration error
- default configuration is loaded
[40] RAM memory error
[41] EEprom memory error
[42] A/D converter error
[43] No communication
[44] Loop error
[45] Invalid configuration type or version
[46] External flash error
[47] Internal flash error
41 0 4 V 1 0 0 - UK
21