Table of Contents
Advertisement
DT9102 B
Function
Sequence of operations 1. Enter the menu by typing in the supervisor code.
Exit from the menu item 1. After finishing the setting, press the MENU button, to exit
Exit from the menu
20180905-V1
Synchronisation time
7.7.
Setting remote synchronisation time. When
selected in
time.
The way the code should be typed in is described in
Chapter 7.1. Type in the code (password). You will see on
the display:
2. Keep stepping by pressing the ▲ button until the menu
item
.
3. Enter the menu item by pressing the ENTER button.
4. You will see the actual synchronisation time on the
display.
5. By pressing the ▲ button you can increase the value of
the blinking digit:
,
,
,
,
•
By pressing the ► button you can select the next digit, so
you can set all the four digits. (after the 4th digit the 1st
digit will appear).
the menu item, and then you will see this:
(2. If you want to change the setting you have just done, or
if you just want to check what you have typed in, go on with
the operation from point 3 of the Sequence of
operations.)
(3. If you don't want to exit the menu, as you want to make
further settings, then you may select the desired menu
items by pressing the ▲ button.)
1. Press the MENU button. First the mnemonic
(Save), then the mnemonic
display. With that, the storing of the settings is completed.
The instrument has exited the menu and goes on with the
measurement.
(05. menu item)
menu item, the clock will set at this
.
,
,
,
,
,
is
, etc.
.
(Exit) are shown on the
33
Advertisement
Table of Contents
