Mounting; General Instructions - Datcon DT9102 I4 Operating Instructions Manual

Mounting positions
Mounting cable entries
10

4. Mounting

4.1. General instructions

Use the enclosed seal when mounting DT9102 I4 on panel
to assure IP 65 protection between the instrument and the
panel from the front side (only panel mounting version).
Electrostatic hazard! Clean only a moist cloth and
detergent.
Select a mounting position you can easily read the display
reach for mounting and connecting the instrument and that
minimises the hazard of water, dust or dump getting into the
instrument.
The insrument is equipped with one M16x1.5 cable entry
and one additional hole equipped with sealing plugs. One
M16x1.5 cable entry is accessory. If required more than one
cable entry (see chapter 5.) put out the sealing plug turning
it in anticlockwise direction. To put in the cable entry use the
sealing turn it in clockwise direction. Tighten the screws so
much that ensures the desired sealing. Use only appropriet
tools.
DT9102 I4
20220103-V0