PIE 820-ELITE Operating Instructions Manual page 30

Frequency Source
Choose this function to provide a frequency signal into any input
devices that measure frequency.
Move the power switch
EZ-DIAL knob to get into the Double Click Menu. Turn the knob
to scroll through the settings and press the knob to make your
selection. Select FREQ for the FUNCTION and 20KHZ,
10000HZ, 1000HZ or 2000CPM for the RANGE.
Disconnect all input wires from the devices to be calibrated and
connect the PIE 820-ELITE to the input of the device matching
polarity.
The green HZ SYNC LED pulses in synch with the output pulses
and may be used to calibrate optical pickups. The output signal
is a zero crossing square wave with a fixed amplitude of 6 V
peak-to-peak from -1 and + 5 V.
Instantly output your SPAN and ZERO output settings by moving
the EZ-CHECK switch between HI and LO. You may also select
any third output setting (such as mid-range) using the SET
position on the EZ-CHECK switch. The output is adjusted in 1
count increments by turning the knob
knob for faster dialing with 100 count increments.
HI
mA V pH TC Ω RTD Freq Pressure
Quality PIECAL Products Online at:
20.000
KHz
SOURCE
HI MAX
SET READ
OFF
MIN
LO
READ READ
Double Click
Menu
Push & Turn
for
Fast Dialing
Push & Hold
to
Store/Step
GlobalTestSupply
www.
w to SOURCE then Double Click the
Frequency Receiver Input
Flowmeter
Transmitter
Computer
Logger
Controller
DCS
Page 28
. Press and turn the
e
All Frequency
Connections
.com
sales@GlobalTestSupply.com