Table of Contents
Advertisement
2 Wire SIM mA, 2 Wire SIM % (Percent of 4 to 20 mA)
Choose this function to simulate a 2 Wire Transmitter output from
0.000 to 24.000 milliamps. Operates in loops with power supply
voltages from 2 to 60 VDC.
Move the power switch
EZ-DIAL knob to get into the Double Click Menu. Turn the knob
to scroll through the settings and press the knob to make your
selection. Select mA for the FUNCTION and 2W SIM for the
MODE. Choose either mA or % and whether you need the 250Ω
HART resistor active in the loop.
Connect the output leads of the PIE 820-ELITE to the inputs of
the device being calibrated, making sure to check polarity. Red
lead to the plus (+) input and black lead to the minus (-) input.
Instantly output your SPAN and ZERO output settings by moving
the EZ-CHECK switch between HI and LO (defaults to 20 & 4
mA). You may also select any third output setting (such as
mid-range) using the SET position on the EZ-CHECK switch.
The output is adjusted in 0.001 mA (0.01%) increments by
turning the knob
with 0.100 mA (1.00%) increments.
Powers External
2-Wire Transmitter
Power Supply
(2 to 100 VDC)
Quality PIECAL Products Online at:
e
. Press and turn the knob for faster dialing
Receiver
GlobalTestSupply
www.
w
to SOURCE then Double Click the
20.000
HI
2 WIRE SIM mA
mA V pH TC Ω RTD Freq Pressure
SOURCE
HI
MAX
SET
READ
OFF
LO
MIN
READ
READ
Double Click
Menu
Push & Turn
for
Fast Dialing
Push & Hold
to
Store/Step
Page 13
To
Sensor
+ IN -
REF +OUT-
Typical
2-Wire
Transmitter
(Disconnected)
.com
sales@GlobalTestSupply.com
Advertisement
Table of Contents
