User's Guide ValueJet 1608 HS
Preparations before printing
4.2.3
Nozzle Check
Used to check whether there are any head clogging, missing nozzles or misfiring nozzles.
Note
Note
4.2.4
Mode Print
Used to confirm the following printing conditions:
Note
2009/01/01 0: 00 G 2( 720x720N 8Pass Bi ) - W ave1/Pr e: 30°C/Pl at en: 30°C/Af t er : 30°C/Ai r : 190°C/PF Adj ust : 0
78
Downloaded From ManualsPrinter.com Manuals
If the nozzle check result indicates that the checked points are blurred or
missing, clean the head. Refer to
Perform the nozzle check once again after the head has been cleaned.
For the printing procedure, refer to
Print mode
Pre heater set temperature
Fixer (Platen) heater set temperature
Drier heater Set temperature
Air heater set temperature
Adjustment value
For the printing procedure, refer to
for more information.
Nozzle Check on page 78
Test print on page 75
Test print on page 75
AP-75810 - Revision 2.0