Uniden MHS135 Owner's Manual page 18

When it detects a signal, the radio stays
08
Using the radio in scan mode
x To activate scan mode, press and hold CLR/SCAN.
x You must have at least two channels in memory to start
a scan.
x You cannot transmit while in scan mode.
x To save a channel into memory, select the channel, then
press and hold the GPS/MEM button. The MEM icon
displays whenever you tune to that channel.
x To remove a channel from memory, set the radio to that
channel, then press and hold the GPS/MEM button. The
MEM icon no longer displays.
x When the radio stays on a channel, press Channel Up to
leave that channel and resume scanning.
x To end the scan, press and hold the CLR/SCAN button
again; the radio remains on the last scanned channel.
Scan mode with Weather Alert Watch
If you activate Weather Alert Watch while in scan mode, the
radio checks the most recently-used weather channel every
few seconds, then continues scanning the next channel in
memory:
E-14
on the channel until you press the
Channel Up button or the signal stops.
10 11
The radio scans about
5 channels in 0.5 seconds.
Uniden MHS135 Radio Owner's Manual
12 13 14
Resume
scan
17
15