Windshield Wiper And Washers - Chrysler Pacifica 2017 User Manual

O P E R A T I N G Y O U R V E H I C L E
Turn Signal Warning
If the vehicle electronics sense that the vehicle has traveled at over 18 mph (29 km/h) for about
1 mile (1.6 km) with the turn signals on, a chime will sound and a message will display in the cluster
to alert the driver.
Lane Change Assist — If Equipped
Tap the lever up or down once, without moving beyond the detent, and the turn signal (right or
left) will flash three times then automatically turn off.
High/Low Beam Switch
When the headlights are turned on, pushing the multifunction lever toward the instrument panel
will switch from low beams to high beams. Pulling back to the neutral position returns the
headlights to the low beam operation.

WINDSHIELD WIPER AND WASHERS

The wipers and washers are operated by a switch within the wiper lever. Rotate the end of the
wiper lever to select the desired wiper speed.
NOTE:
Always remove any buildup of snow that pre-
vents the windshield wiper blades from return-
ing to the off position. If the windshield wiper
switch is turned off and the blades cannot re-
turn to the off position, damage to the wiper
motor may occur.
Sudden loss of visibility through the windshield could lead to a collision. You might not see
other vehicles or other obstacles. To avoid sudden icing of the windshield during freezing
weather, warm the windshield with the defroster before and during windshield washer use.
Intermittent Wiper System
Use the intermittent wiper when weather conditions make a single wiping cycle with a variable
pause between cycles desirable. Rotate the end of the wiper lever to the first detent position, and
then turn the end of the lever to select the desired delay interval. There are four delay settings,
Washer And Wiper Controls
WARNING!
93