Chrysler Pacifica 2017 User Manual page 66

G E T T I N G S T A R T E D
1. Look behind the seating position where you plan to install the child restraint to find the tether
anchorage. You may need to move the seat forward to provide better access to the tether
anchorage. If there is no top tether anchorage for that seating position, move the child
restraint to another position in the vehicle if one is available.
2. Route the tether strap to provide the most
direct path for the strap between the anchor
and the child seat. If your vehicle is
equipped with adjustable rear head re-
straints, raise the head restraint, and where
possible, route the tether strap under the
head restraint and between the two posts. If
not possible, lower the head restraint and
pass the tether strap around the outboard
side of the head restraint.
3. Attach the tether strap hook of the child
restraint to the top tether anchorage as
shown in the diagram.
4. Remove slack in the tether strap according to the child restraint manufacturer's instructions.
• An incorrectly anchored tether strap could lead to increased head motion and possible
injury to the child. Use only the anchorage position directly behind the child seat to secure
a child restraint top tether strap.
• If your vehicle is equipped with a split rear seat, make sure the tether strap does not slip into
the opening between the seatbacks as you remove slack in the strap.
64
Top Tether Anchorage Locations 3rd Row
Rear Seat Tether Strap Attachment
(Second Row Anchorage Shown)
WARNING!