Removing The Ide/Audio Board And Microphone - NEC Versa P700 Disassembly Manual

Removing the LCD
disk drive cover (see
Removing the Touchpad), remove the heat plate (see
plastic cover (see
1. Remove the screw holding the LED board in place.
2. Disconnect the LED board connector from the main board and put the LED board aside.

Removing the IDE/Audio Board and Microphone

To remove the IDE/Audio board and microphone, first remove the keyboard (see
the Keyboard), remove the LED assy (see
assembly (see Removing the LCD
remove the Hard disk drive (see
assembly (see Removing the
Plate), remove the plastic cover (see
steps:
1. Disconnect the speaker set connector (see
2. Disconnect the microphone connector and put the microphone aside.
3. Remove the screws marked in the picture below.
Display), remove the heat sink (see
Removing the Hard Disk
Removing the Plastic Cover), then perform the next steps:
Fig. 44: Removing the wireless LED board
Display), remove the heat sink (see
Removing the Hard Disk
Touchpad), remove the heat plate (see
Removing the Plastic
Fig. 45: Removing the IDE/Audio board
NEC Versa P700 Disassembly Manual
Removing the
Drive), remove the touchpad assembly (see
Removing the Heat
Removing the LED Assy), remove the LCD
Drive), remove the touchpad
Cover), then perform the next
Removing the Speaker
CPU), remove the Hard
Plate), remove the
Removing
Removing the CPU),
Removing the Heat
Set).
(M2x3)
(M2.5x5)
Page 23