Removing The Plastic Cover - NEC Versa P700 Disassembly Manual

2. Take the battery out of the system and put it aside.

Removing the Plastic Cover

To remove the plastic cover, first remove the keyboard (see
the LED assy (see
LCD Display), remove the heat sink (see
cover (see Removing the Hard Disk
the Touchpad), remove the heat plate (see
steps:
1. Remove the screw on the bottom of the system at the VersaBay location (see picture
below).
2. Remove the screws marked in the next picture
Fig. 39: Disconnecting the CMOS battery
Removing the LED Assy), remove the LCD assembly (see
Removing the
Drive), remove the touchpad assembly (see
Fig. 40: Removing screw in VersaBay location
Fig. 41: Removing the plastic cover
NEC Versa P700 Disassembly Manual
Removing the
CPU), remove the Hard disk drive
Removing the Heat Plate), then perform the next
Keyboard), remove
Removing the
Removing
(Cone 2.5X3)
A (M2x4)
B (M2.5x5)
Page 21