Removing The Heat Plate; Removing The Cmos Battery - NEC Versa P700 Disassembly Manual

5. Carefully lift the CPU from the CPU socket and put it aside.

Removing the Heat Plate

To remove the heat plate, first remove the keyboard (see
the LED assy (see
remove the Hard disk drive cover (see
assembly (see Removing the
1. Remove the seven screws marked in the next picture.
2. Carefully lift out the front side of heat plate from the system, slide the heat plate slightly
towards the left side to free it from the plastic cover and put it aside.

Removing the CMOS Battery

To remove the CMOS battery, first remove the keyboard (see
follow the next steps:
1. Disconnect the battery connector from the main board (see picture below).
Fig. 37: Unlocking the CPU
Removing the LED Assy), remove the heat sink (see
Removing the Hard Disk
Touchpad), then perform the following steps:
Fig. 38: Removing the heat plate screws
NEC Versa P700 Disassembly Manual
Removing the Keyboard), remove
Removing the
Drive), remove the touchpad
Removing the Keyboard), then
CPU),
A (M2x2)
B (M2x10)
C (M2.5x5)
D (M2x4)
Page 20