Sony PXW-Z450 Operating Instructions Manual page 60

000 60
5. Network Configuration: Connecting Devices using Wireless LAN
2
Turn the camcorder on, and set Maintenance
>Network >Wireless Network to Wi-Fi Access
Point.
3
Set Maintenance >Network >Setting to On.
4
Enable the NFC function.
Set NFC connection mode by executing
Maintenance >Network >NFC in the setup
menu or by pressing and holding an
assignable switch that has been assigned with
the NFC function for three seconds.
The NFC function can be used only when
displayed on the screen.
[Note]
It may take some time (30 seconds to 90 seconds) for
appear on the screen. Wait until the network "AP" (access
point) wireless network indicator (page 17) stops flashing
on the viewfinder screen.
5
Touch the device against the camcorder.
The device connects to the camcorder, and
"Content Browser Mobile" launches.
[Notes]
ˎ Wake a sleeping device and unlock the lock screen ˎ
beforehand.
ˎ Continue to hold the device against the camcorder ˎ
without moving it until "Content Browser Mobile"
launches (1 to 2 seconds).
ˎ If a device with identical SSID has already been registered, ˎ
the device may not be able to be connected, depending
on the OS version of the device. In this case, you can
connect the device by deleting the registered SSID from
the device.
Connecting using WPS-equipped devices
Devices that support WPS can be connected using
WPS.
1
Set Maintenance >Network >Wireless Network
to Wi-Fi Access Point.
2
Set Maintenance >Network >Setting to On.
[Note]
It may take some time (30 seconds to 90 seconds) to enable
access point mode. Wait until the network "AP" (access point)
indicator (page 17) stops flashing on the LCD monitor or
in the viewfinder.
is
3
Select Maintenance >Network >WPS in the
setup menu.
to
4
Turn the MENU knob to select [Execute], then
press the knob.
5
Open the device Network Settings or Wi-Fi
Settings, and turn Wi-Fi on.
6
Select the camcorder SSID from the Wi-Fi
network SSID list, display Option, and select
WPS Push Button.
[Note]
The steps will vary depending on the device used.
Connecting using SSID and password on the
device
Connect by entering the SSID and password on
the device.
1
Set Maintenance >Network >Wireless Network
to Wi-Fi Access Point.
2
Set Maintenance >Network >Setting to On.
[Note]
It may take some time (30 seconds to 90 seconds) to enable
access point mode. Wait until the net work "AP" (access
point) indicator (page 17) stops flashing on the LCD
monitor or in the viewfinder.
3
Open the device Network Settings or Wi-Fi
Settings, and turn Wi-Fi on.
4
Select the camcorder SSID from the Wi-Fi
network SSID list, then enter a password to
connect.
For the camcorder SSID and password, see
Maintenance >Network >SSID & Password
(page 107) in the setup menu.
[Note]
The steps will vary depending on the device used.
Connecting Using Wireless LAN
Station Mode (Wi-Fi Station Mode)
The camcorder can connect to an existing wireless
LAN access point as a client.
The device connects via the access point.
Computer
Smartphone/
Tablet
Access
point
Connecting to an access point using WPS
If an access point supports the WPS function, you
can connect using a basic setting. If an access
point does not support the WPS function, see
"Connecting to an access point in station mode
without using WPS" (page 73).
1
Turn the access point on.
2
Turn the camcorder on.
3
Set Maintenance >Network >Wireless Network
to Wi-Fi Station.
4
Set Maintenance >Network >Setting to On.