Configuring The Switch Settings - Cisco Catalyst 3560 Hardware Installation Manual

Configuring the Switch Settings

Note
Configuring the Switch Settings
Catalyst 3560 Switch Hardware Installation Guide
1-8
Did you enter the wrong address in the browser, or is there an error message
•
displayed in the browser window?
Re-enter 10.0.0.1 in the browser, and press Enter.
• Did you connect a crossover instead of a straight-through Ethernet cable
between an Ethernet port of the switch and the Ethernet port of the PC or
workstation, as shown
Note See Figure B-8 on page B-7
cable.
Many legacy powered devices, including older Cisco IP phones and
Note
access points that do not fully support IEEE 802.3AF, might not support
Power over Ethernet (PoE) when connected to the switches by a crossover
cable.
If not, reconnect the cable to the Ethernet port on the switch and PC or
workstation. Wait 30 seconds before entering 10.0.0.1 in the browser.
Did you verify that POST successfully ran before starting Express Setup?
•
If not, make sure that only the SYST and STAT LEDs are green before
pressing the Mode button to begin Express Setup.
The rest of this chapter explains how to configure a switch by using the Express
Setup web page. To configure the switch by using the command-line interface
(CLI)-based setup program, see
CLI-Based Setup Program."
The Management Interface field displays VLAN1-Default. This is the
management interface through which you manage the switch and to which you
assign IP information.
Figure 1-5.
for instructions on identifying a crossover
Appendix C, "Configuring the Switch with the
Chapter 1 Using Express Setup
78-16057-01