Cisco Catalyst 3560 Hardware Installation Manual page 54

Front Panel Description
Table 2-3 Modes for Port LEDs
Selected Mode
LED Port Mode
STAT Port status
DUPLX Port duplex mode
SPEED Port speed
PoE 10/100 PoE port power
1. When installed in Catalyst 3560 switches, 1000BASE-T SFP modules can operate at 10, 100, or 1000 Mbps in full-duplex
mode or at 10 or 100 Mbps in half-duplex mode.
Table 2-4 PoE Mode LED
Color PoE Status
Off PoE mode is not selected. None of the 10/100 ports have been denied power or are
in a fault condition.
Green PoE mode is selected, and the PoE status is shown on the port LEDs.
Blinking amber PoE mode is not selected. At least one of the 10/100 ports has been denied power,
or at least one of the 10/100 ports has a PoE fault.
Catalyst 3560 Switch Hardware Installation Guide
2-10
To select or change a mode, press the Mode button until the desired mode is
highlighted. When you change port modes, the meanings of the port LED colors
also change. Table 2-5
port modes.
Even if PoE mode is not selected, the PoE LED still shows PoE problems when
they are detected.
Table 2-4 lists the PoE mode LED colors and their meanings.
explains how to interpret the port LED colors in different
Description
The port status. This is the default mode.
The port duplex mode: full duplex or half duplex.
The port operating speed: 10, 100, or 1000
The PoE status.
Chapter 2 Product Overview
1
Mbps.
78-16057-01