Connecting To A Power Source - Cisco Catalyst 3560 Hardware Installation Manual

Connecting to a Power Source

Step 1
Step 2

Connecting to a Power Source

Step 1
Step 2
Note
Catalyst 3560 Switch Hardware Installation Guide
C-6
Follow these steps to start a terminal-emulation session:
Start the terminal-emulation program if you are using a PC or terminal.
Configure the baud rate and character format of the PC or terminal to match these
console port default characteristics:
9600 baud
•
8 data bits
•
1 stop bit
•
No parity
•
None (flow control)
•
Follow these steps to connect to a power source:
Connect one end of the supplied AC power cord to the power connector on a
switch rear panel. See
Connect the other end of the power cable to a grounded AC outlet.
If you are connecting the switch to a Cisco redundant power system (RPS), refer
to the documentation that shipped with your RPS.
As the switch powers on, it begins POST, a series of tests that run automatically
to ensure that the switch functions properly. If POST fails, see
"Troubleshooting," to determine a course of action.
If you started the terminal emulation program before you powered on your switch,
the PC or terminal displays the bootloader sequence. You need to press Enter to
display the setup program prompt.
Appendix C Configuring the Switch with the CLI-Based Setup Program
Figure C-2.
Chapter 4,
78-16057-01