Installing The Switch; Rack Mounting; Removing Screws From The Switch; Attaching Brackets To The Catalyst 3560 Switch - Cisco Catalyst 3560 Hardware Installation Manual

Installing the Switch

Installing the Switch

Rack Mounting

Warning
Catalyst 3560 Switch Hardware Installation Guide
3-14
This section describes these installation procedures:
Rack Mounting, page 3-14
•
Wall Mounting, page 3-20
•
Table or Shelf Mounting, page 3-24
•
To install the switch in a 19-inch or 24-inch rack (24-inch racks require optional
mounting hardware), follow the instructions described in these procedures:
Removing Screws from the Switch, page 3-15
•
Attaching Brackets to the Catalyst 3560 Switch, page 3-16
•
Mounting the Switch in a Rack, page 3-19
•
Attaching the Cable Guide, page 3-20
•
To prevent bodily injury when mounting or servicing this unit in a rack, you
must take special precautions to ensure that the system remains stable. The
following guidelines are provided to ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the
top with the heaviest component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting
or servicing the unit in the rack.
Chapter 3 Switch Installation
78-16057-01