Cisco Catalyst 3560 Hardware Installation Manual page 83

Chapter 3 Switch Installation
Figure 3-13 Mounting the Switch on a Wall
1
1
User-supplied screws
78-16057-01
After the switch is mounted on the wall, you need to do these tasks to complete
the installation:
• Power on the switch. See the
Connect to a 10/100 port, and run Express Setup. See the
•
Setup" section on page
Connect to the front-panel ports. See the
•
section on page 3-29
page 3-32 to complete the installation.
For configuration instructions about using the CLI setup program, go to
Appendix C, "Configuring the Switch with the CLI-Based Setup Program."
"Powering On the Switch" section on page
1-4.
"Connecting to the 10/100 Ports"
and the "Connecting to SFP Modules" section on
Catalyst 3560 Switch Hardware Installation Guide
Installing the Switch
1
1-3.
"Starting Express
3-23