Cisco Catalyst 3560 Hardware Installation Manual page 86

Installing and Removing SFP Modules
To insert an SFP module into the module slot, follow these steps:
Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on
Step 1
the chassis.
Find the send (TX) and receive (RX) markings that identify the top side of the SFP
Step 2
module.
Note
Align the SFP module in front of the slot opening.
Step 3
Insert the SFP module into the slot until you feel the connector on the module snap
Step 4
into place in the rear of the slot.
Figure 3-15 Installing an SFP Module into an SFP Module Slot
For fiber-optic SFP modules, remove the dust plugs from the optical ports, and
Step 5
store them for later use.
Catalyst 3560 Switch Hardware Installation Guide
3-26
On some SFP modules, the send and receive (TX and RX) markings might
be replaced by arrows that show the direction of the connection, either
send or receive (TX or RX).
4 0
4 1
4 2
4 3
4 4
4 5
4 6
4 7
4 8
47 X
48 X
C a t a ly s t
3 5 6 0
P o E - 4 8
S E R IE S
1
3
2
4
Chapter 3 Switch Installation
78-16057-01