Connecting An Airflow Sensor; Connecting An Airflow Sensor; Connecting Inputs And Outputs; Connecting Inputs And Outputs - Nailor BAC-8001-36 Installation And Operation Manual

Connecting an Airflow Sensor
An airflow sensor is incorporated as one of the inputs to the controller. Remove the plugs and connect the tubing from the pitot
assembly to the airflow sensor inputs next to the drive hub.
Figure 2-3 Airflow sensor inputs
Static airflow
(low)
Diamond Flow
Sensor
Total airflow
(high)
Diamond flow sensors are supplied by Nailor as part of the VAV terminal unit. If a sensor is needed, choose a sensor listed in the
topic Accessories and Replacement Parts on page 48. For more information on Nailor's 'Diamond Flow' Sensor, see page 48 or
refer to Nailor website.
Connecting Inputs and Outputs
Nailor EZvav series controllers have preconfigured inputs and outputs to support only the supplied programs and applications.
• For input and output connection information, see the topic Application drawings on page 29.
• To connect room temperature sensors, see the topic Connecting room temperature sensors on page 9.
• To connect a DAT sensor, see the topic Connecting a DAT sensor on page 10.
• For the BACnet object descriptions of the inputs and outputs, see the topic BACnet objects on page 44.
Connecting Room Temperature Sensors
Connect any of the following sensors to the RJ-45 thermostat and sensor jack. The controller automatically detects the type of
sensor. No programming or configuration is required.
• STE-6014W36
• STE-8001W36
• STE-8201W36
Connect the controller to sensors with standard Ethernet cables up to 75 feet long.
Figure 2-4 Connecting to a sensor
Date: 10-2016 Supersedes: 7-2016
Nailor reserves the right to change any information concerning product or specification without notice or obligation.
Installation and Operation Manual
EZvav
Digital Controller
Page 9 of 48
EZvav Digital Controls
●
Static airflow (low)
Ethernet cable
Maximum 75 feet
Total airflow (high)
IOM-EZVAVINST