Section 3: Installing The Room Sensors; Choosing A Sensor Location; Rough-In Preparation; Mount The Sensors - Nailor BAC-8001-36 Installation And Operation Manual

Section 3: Installing the Room Sensors
An airflow sensor is incorporated as one of the inputs to the controller. Remove the plugs and connect the tubing from the pitot
assembly to the airflow sensor inputs next to the drive hub.
EZvav Sensors:
This applies to EZvav digital display wall sensors connected to EZvav controllers.
Choosing a sensor location
Install the sensor on an inside wall where it can sense the average room temperature. Avoid locations with direct sunlight, heat
sources, windows, air vents, and air circulation obstructions such as curtains or furniture.
For models with motion sensing, see the topic on the page 12, Planning for motion sensing.
Rough-in preparation
Complete rough-in wiring at each sensor location prior to sensor installation. This includes the following items:
• If required, install an appropriate backplate.
• Route an Ethernet connecting cable from the sensor to the controller location.
• Maximum cable length is 75 feet (22.9 meters). Plenum-rated preassembled cables are recommended.
Ethernet Connecting
Cable
Maximum 75 feet
(22.9 meters)

Mount the sensors

To install the sensor on a mounting base, do the following:
1. Turn the Allen screws in the base of the sensor clockwise until they clear the case. Swing the sensor away from the
mounting base to remove it.
Date: 10-2016 Supersedes: 7-2016
Nailor reserves the right to change any information concerning product or specification without notice or obligation.
Installation and Operation Manual
STE-8001W36
Digital Display
Mounting
Base
Allen
Screws
Page 11 of 48
EZvav Digital Controls
●
STE-8201W36
Digital Display with Occupancy Sensor
Turn screws clockwise to
remove sensor case from base.
IOM-EZVAVINST