Table of Contents
Advertisement
Checking/Adjusting. Guide. Post. Parallel. with.
Blade.Front-to-Back
1. DISCONNECT MACHINE FROM POWER!
2. Loosen guide post lock knob, lower blade guide
assembly all the way, then tighten lock knob.
3. Remove (2) M5-.8 x 10 cap screws and 5mm flat
washers that secure guide post guard, then carefully
remove guard (see Figures 94–95).
Note: It helps to rotate guard counterclockwise
while removing it.
4. Measure distance "A" between upper front face of
guide post rack and back of blade (see Figure 96).
5. Measure distance "B" between bottom front face of
guide post rack and back of blade (see Figure 96).
— If measurements taken in Steps 4–5 are equal, no
adjustments need to be made. Go to Step 9.
— If measurements taken in Steps 4–5 are not equal,
proceed to Step 6.
Model W1849 (For Machines Mfd. Since 11/16)
Figure 94. Location of cap screws and flat
washers that secure guide post guard.
Figure 95. Guide post guard removed.
Distance "A"
(Right Side View)
Distance "B"
Figure 96. Example of measuring distance
between guide post rack and blade.
-68-
Cap Screws and
Flat Washers
Advertisement
Table of Contents
