Table of Contents
Advertisement
Model W1849 (For Machines Mfd. Since 11/16)
Blade.Tension.Adjustment.Assembly
Lubrication Type .................. GL2 Grease or Equivalent
Amount ................................................ Thin Coat
Frequency ............................................ As Needed
To lubricate tension adjustment assembly, do these
steps:
1. DISCONNECT MACHINE FROM POWER!
2. Open upper wheel cover and look through top of
wheel (see Figure 81).
3. Use a rag and mineral spirits to wipe off any grease
and sawdust build-up on blade tension adjustment
assembly and tension lever cam (see Figure 82),
then apply thin coat of lubricant to these areas.
Trunnions
The steel trunnions (see Figure 83) should be regularly
wiped clean with mineral spirits and lubricated with a
thin coat of GL2 grease on the sliding surfaces.
Look Through Here
Figure 81. Location of blade tension
adjustment assembly.
Cam
Figure 82. Lubrication locations for
tension adjustment assembly (wheel
removed for clarity).
Figure 83. Lubrication areas on the
-59-
Adjustment
Assembly
Sliding Surfaces
trunnion.
Advertisement
Table of Contents
