The Catalog Of Programs (Mem); Clearing One Or More Programs - HP -32S Owner's Manual

If during program entry you encounter the message MEMORY FULL,
then there is not enough room in program memory for the line you
just tried to enter. You can make more room available by clearing pro
grams or other data. See "Clearing One or More Programs" below, or
"Managing Calculator Memory* in appendix B.
The Catalog of Programs (MEM)
The catalog of programs is a list of all program labels with the num
ber of bytes of memory used by each label and the lines associated
with it. Press fill mem I{PGM} to display the catalog, and press [r] or
§§(a] to move within the list. You can use this catalog to:
• Review the labels in program memory and the memory cost of each
labeled program or routine.
• Execute a labeled program. (Press fxlcn or [rTsI while the label is
displayed.)
• Display a labeled program. (Press Hi prgm I while the label is
displayed.)
n Delete specific programs. (Press Hi clear Iwhile the label is
displayed.)
• See the checksum associated with a given program segment. (Press
•fSHOWl.)
The catalog shows you how many bytes of memory each labeled pro
gram segment uses. The programs are identified by program label:
LBL C 831.5
Number of bytes used by program C
Clearing One or More Programs
To clear (delete from memory) a specific program:
1. Press Bl mem I {PGM} and display (using [T) and HH)the label
of the program.
5: Simple Programming 85