Configuring Network Parameters Assignment - HP 6125XLG Layer 3-Ip Services Configuration Manual

Step
2. (Optional.) Specify the IPv6
addresses excluded from
dynamic assignment.
3. Create a DHCPv6 address
pool and enter its view.
4. Specify an IPv6 subnet for
dynamic assignment.
5. (Optional.) Specify a
non-temporary IPv6 address
range.
6. (Optional.) Specify a
temporary IPv6 address
range.
7. (Optional.) Create a static
binding.

Configuring network parameters assignment

In addition to IPv6 prefixes and IPv6 addresses, you can configure up to eight DNS server addresses, one
domain name suffix, eight SIP server addresses, and eight SIP server domain names in an address pool.
To configure network parameters assignment:
Step
1. Enter system view.
2. Create a DHCPv6 address
pool and enter its view.
Command
ipv6 dhcp server forbidden-address
start-ipv6-address
[ end-ipv6-address ]
ipv6 dhcp pool pool-name
network prefix/prefix-length
[ preferred-lifetime
preferred-lifetime valid-lifetime
valid-lifetime ]
address range start-ipv6-address
end-ipv6-address
[ preferred-lifetime
preferred-lifetime valid-lifetime
valid-lifetime ]
temporary address range
start-ipv6-address end-ipv6-address
[ preferred-lifetime
preferred-lifetime valid-lifetime
valid-lifetime ]
static-bind address
ipv6-address/addr-prefix-length |
duid duid [ iaid iaid ]
[ preferred-lifetime
preferred-lifetime valid-lifetime
valid-lifetime ]
Command
system-view
ipv6 dhcp pool pool-name
170
Remarks
By default, all IPv6 addresses
except for the DHCPv6 server's IP
address in a DHCPv6 address
pool are assignable.
If the excluded IPv6 address is in
a static binding, the address still
can be assigned to the client.
To exclude multiple IPv6 prefix
ranges, repeat this step.
By default, no DHCPv6 address
pool is configured.
By default, no IPv6 address
subnet is specified.
You cannot use this command to
configure the same subnet in
different address pools.
By default, no non-temporary IPv6
address range is specified, and
all unicast addresses on the
subnet are assignable.
By default, no temporary IPv6
address range is specified, and
the DHCPv6 server cannot assign
temporary IPv6 addresses.
By default, no static binding is
configured.
To add more static bindings,
repeat this step.
Remarks
N/A
By default, no DHCPv6
address pool exists on the
DHCPv6 server.