HP 6125XLG Layer 3-Ip Services Configuration Manual page 219

# Specify an IPv4 address for VLAN-interface 100.
<SwitchA> system-view
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ip address 192.168.100.1 255.255.255.0
[SwitchA-Vlan-interface100] quit
# Specify an IPv6 address for VLAN-interface 101.
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] ipv6 address 3002::1 64
[SwitchA-Vlan-interface101] quit
# Create service loopback group 1 and specify its service type as tunnel.
[SwitchA] service-loopback group 1 type tunnel
# Add Ten-GigabitEthernet 1/1/5 to service loopback group 1.
[SwitchA] interface Ten-GigabitEthernet 1/1/5
[SwitchA-Ten-GigabitEthernet1/1/5] port service-loopback group 1
[SwitchA-Ten-GigabitEthernet1/1/5] quit
# Configure an IPv6 over IPv4 manual tunnel interface tunnel 0.
[SwitchA] interface tunnel 0 mode ipv6-ipv4
# Specify an IPv6 address for the tunnel interface.
[SwitchA-Tunnel0] ipv6 address 3001::1/64
# Specify VLAN-interface 100 as the source interface of the tunnel interface.
[SwitchA-Tunnel0] source vlan-interface 100
# Specify the destination address for the tunnel interface as the IP address of the VLAN-interface
100 on Switch B.
[SwitchA-Tunnel0] destination 192.168.50.1
[SwitchA-Tunnel0] quit
# Configure a static route destined for IPv6 network 2 through tunnel 0 on Switch A.
[SwitchA] ipv6 route-static 3003:: 64 tunnel 0
2. Configure Switch B:
# Specify an IPv4 address for VLAN-interface 100.
<SwitchB> system-view
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] ip address 192.168.50.1 255.255.255.0
[SwitchB-Vlan-interface100] quit
# Specify an IPv6 address for VLAN-interface 101.
[SwitchB] interface vlan-interface 101
[SwitchB-Vlan-interface101] ipv6 address 3003::1 64
[SwitchB-Vlan-interface101] quit
# Create service loopback group 1 and specify its service type as tunnel.
[SwitchB] service-loopback group 1 type tunnel
# Add Ten-GigabitEthernet 1/1/5 to service loopback group 1.
[SwitchB] interface Ten-GigabitEthernet 1/1/5
[SwitchB-Ten-GigabitEthernet1/1/5] port service-loopback group 1
[SwitchB-Ten-GigabitEthernet1/1/5] quit
# Configure an IPv6 over IPv4 manual tunnel interface tunnel 0.
[SwitchB] interface tunnel 0 mode ipv6-ipv4
208