Troubleshooting Dhcp Server Configuration; Symptom; Analysis - HP 6125XLG Layer 3-Ip Services Configuration Manual

The DHCP server assigns PXE server addresses to DHCP clients through Option 43, a customized option.
The format of Option 43 and that of the PXE server address sub-option are shown in
16. The value of Option 43 configured on the DHCP server in this example is 80 0B 00 00 02 01 02 03
04 02 02 02 02. The number 80 is the value of the sub-option type. The number 0B is the value of the
sub-option length. The numbers 00 00 are the value of the PXE server type. The number 02 indicates the
number of servers. The numbers 01 02 03 04 02 02 02 02 indicate that the PXE server addresses are
1.2.3.4 and 2.2.2.2.
Figure 21 Network diagram
Configuration procedure
1. Specify IP addresses for the interfaces. (Details not shown.)
2. Configure the DHCP server:
# Enable DHCP.
<SwitchA> system-view
[SwitchA] dhcp enable
# Enable the DHCP server on VLAN-interface 2.
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] dhcp select server
[SwitchA-Vlan-interface2] quit
# Configure DHCP address pool 0.
[SwitchA] dhcp server ip-pool 0
[SwitchA-dhcp-pool-0] network 10.1.1.0 mask 255.255.255.0
[SwitchA-dhcp-pool-0] option 43 hex 800B0000020102030402020202
Verifying the configuration
After the preceding configuration is complete, Switch B can obtain its IP address on 10.1.1.0/24 and the
PXE server addresses from the Switch A. You can use the display dhcp server ip-in-use command on the
DHCP server to display the IP addresses assigned to the clients.

Troubleshooting DHCP server configuration

Symptom

A client's IP address obtained from the DHCP server conflicts with another IP address.

Analysis

Another host on the subnet might have the same IP address.
53
Figure 14 and Figure