HP 6125XLG Layer 3-Ip Services Configuration Manual page 246

Blade switch
Table of Contents

Advertisement

Figure 96 Network diagram
Switch A
XGE1/1/5
XGE1/1/7
Vlan-int100
10.1.1.1/24
IPv4
Group 1
Configuration procedure
Before the following configurations, configure an IP address for each interface, and make sure Switch A
and Switch B can reach each other.
1.
Configure Switch A:
# Create service loopback group 1, and configure the service type as tunnel.
<SwitchA> system-view
[SwitchA] service-loopback group 1 type tunnel
# Add port Ten-GigabitEthernet1/1/5 to service loopback group 1.
[SwitchA] interface Ten-GigabitEthernet 1/1/5
[SwitchA-Ten-GigabitEthernet1/1/5] port service-loopback group 1
[SwitchA-Ten-GigabitEthernet1/1/5] quit
# Create a tunnel interface Tunnel 0, and specify the tunnel mode as GRE over IPv6.
[SwitchA] interface tunnel 0 mode gre ipv6
# Configure an IP address for the tunnel interface.
[SwitchA-Tunnel0] ip address 10.1.2.1 255.255.255.0
# Configure the source address of the tunnel interface as the IPv6 address of VLAN-interface 101
on Switch A.
[SwitchA-Tunnel0] source 2002::1:1
# Configure the destination address of the tunnel interface as the IPv6 address of VLAN-interface
101 on Switch B.
[SwitchA-Tunnel0] destination 2001::2:1
[SwitchA-Tunnel0] quit
# Configure a static route from Switch A through the tunnel interface to Group 2.
[SwitchA] ip route-static 10.1.3.0 255.255.255.0 tunnel 0
2.
Configure Switch B:
# Create service loopback group 1, and configure the service type as tunnel.
<SwitchB> system-view
[SwitchB] service-loopback group 1 type tunnel
# Add port Ten-GigabitEthernet1/1/5 to service loopback group 1.
[SwitchB] interface Ten-GigabitEthernet 1/1/5
[SwitchB-Ten-GigabitEthernet1/1/5] port service-loopback group 1
[SwitchB-Ten-GigabitEthernet1/1/5] quit
# Create a tunnel interface Tunnel 0, and specify the tunnel mode as GRE over IPv6.
[SwitchB] interface tunnel 0 mode gre ipv6
XGE1/1/6
Vlan-int101
2002::1:1/64
IPv6 network
GRE tunnel
Tunnel0
10.1.2.1/24
Service loopback port
XGE1/1/6
Switch B
Vlan-int101
2001::2:1/64
XGE1/1/5
XGE1/1/7
Vlan-int100
Tunnel0
10.1.3.1/24
10.1.2.2/24
IPv4
Group 2
235

Advertisement

Table of Contents
loading

Table of Contents