HP 6125XLG Layer 3-Ip Services Configuration Manual page 234

[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ipv6 address 2002:1::1 64
[SwitchA-Vlan-interface100] quit
# Specify an IPv6 address for VLAN-interface 101, which is the physical interface of the tunnel.
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] ipv6 address 2001::11:1 64
[SwitchA-Vlan-interface101] quit
# Create service loopback group 1 and specify its service type as tunnel.
[SwitchA] service-loopback group 1 type tunnel
# Assign Ten-GigabitEthernet 1/1/5 to service loopback group 1.
[SwitchA] interface Ten-GigabitEthernet 1/1/5
[SwitchA-Ten-GigabitEthernet1/1/5] port service-loopback group 1
[SwitchA-Ten-GigabitEthernet1/1/5] quit
# Create an IPv6 tunnel interface tunnel 1.
[SwitchA] interface tunnel 1
# Specify an IPv6 address for the tunnel interface.
[SwitchA-Tunnel1] ipv6 address 3001::1:1 64
# Specify the IP address of VLAN-interface 101 as the source address for the tunnel interface.
[SwitchA-Tunnel1] source 2001::11:1
# Specify the IP address of VLAN-interface 101 on Switch B as the destination address for the
tunnel interface.
[SwitchA-Tunnel1] destination 2002::22:1
[SwitchA-Tunnel1] quit
# Configure a static route destined for the IPv6 network group 2 through the tunnel interface.
[SwitchA] ipv6 route-static 2002:3:: 64 tunnel 1
2. Configure Switch B:
# Specify an IPv6 address for VLAN-interface 100.
<SwitchB> system-view
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] ipv6 address 2002:3::1 64
[SwitchB-Vlan-interface100] quit
# Specify an IPv6 address for VLAN-interface 101, which is the physical interface of the tunnel.
[SwitchB] interface vlan-interface 101
[SwitchB-Vlan-interface101] ipv6 address 2002::22:1 64
[SwitchB-Vlan-interface101] quit
# Create service loopback group 1 and specify its service type as tunnel.
[SwitchB] service-loopback group 1 type tunnel
# Assign Ten-GigabitEthernet 1/1/5 to service loopback group 1.
[SwitchB] interface Ten-GigabitEthernet 1/1/5
[SwitchB-Ten-GigabitEthernet1/1/5] port service-loopback group 1
[SwitchB-Ten-GigabitEthernet1/1/5] quit
# Create an IPv6 tunnel interface tunnel 2.
[SwitchB] interface tunnel 2 mode ipv6
# Specify an IPv6 address for the tunnel interface.
[SwitchB-Tunnel2] ipv6 address 3001::1:2 64
223