Multiport Arp Entry Configuration Example - HP 6125XLG Layer 3-Ip Services Configuration Manual

Figure 4 Network diagram
Configuration procedure
# Create VLAN 10.
<Switch> system-view
[Switch] vlan 10
[Switch-vlan10] quit
# Add interface Ten-GigabitEthernet 1/1/5 to VLAN 10.
[Switch] interface Ten-GigabitEthernet 1/1/5
[Switch-Ten-GigabitEthernet1/1/5] port access vlan 10
[Switch-Ten-GigabitEthernet1/1/5] quit
# Create VLAN-interface 10 and configure its IP address.
[Switch] interface vlan-interface 10
[Switch-vlan-interface10] ip address 192.168.1.2 8
[Switch-vlan-interface10] quit
# Configure a static ARP entry that has IP address 192.168.1.1, MAC address 00e0-fc01-0000, and
output interface Ten-GigabitEthernet 1/1/5 in VLAN 10.
[Switch] arp static 192.168.1.1 00e0-fc01-0000 10 Ten-GigabitEthernet 1/1/5
# Display information about static ARP entries.
[Switch] display arp static
Type: S-Static
IP address
192.168.1.1

Multiport ARP entry configuration example

Network requirements
As shown in
Ten-GigabitEthernet 1/1/6, and Ten-GigabitEthernet 1/1/7 in VLAN 10. The servers share the IP
address 192.168.1.1/24 and MAC address 00e0-fc01-0000.
Configure a multiport ARP entry to send IP packets with destination IP address 192.168.1.1 to the three
servers.
D-Dynamic
MAC address
00e0-fc01-0000
Figure 5, a switch connects to three servers through interfaces Ten-GigabitEthernet 1/1/5,
O-Openflow M-Multiport
VLAN Interface
10 XGE1/1/5
9
I-Invalid
Aging Type
N/A S