PR 5725 User Manual page 12

Input:
General:
Frequency range ......................................... 0.001...50 kHz
Period .......................................................... 999.9...20 µs
Response time (0...90%, 100...10%) .......... Period + 0.1 sec.
Max. offset................................................... 90% of selected max. frequency
Low cut off frequency ................................. 0.001 Hz
Low cut off period time ............................... 1111 sec.
Min. pulse width (without filter) ................... 25 µs
Min. period (without filter) ........................... 50 µs
Max. frequency (without filter) ..................... 50 kHz
Min. pulse width (with filter) ........................ 10 ms
Min. period (with filter) ................................. 20 ms
Max. frequency (with filter) .......................... 50 Hz
NAMUR input acc. to DIN 19234:
Trig-level LOW ............................................. ≤ 1.2 mA
Trig-level HIGH ............................................ ≥ 2.1 mA
Input impedance ......................................... 1 kΩ ± 5% || ≤ 1.5 nF
Breakage detection ..................................... ≤ 0.1 mA
Short-circuit detection................................. ≥ 7.0 mA
Sensor supply (not configurable) ................ 8.3 V ±0.2 V
Tacho input:
Trig-level LOW ............................................. ≤ -50 mV
Trig-level HIGH ............................................ ≥ 50 mV
Input impedance ......................................... ≥ 100 kΩ ± 5% || ≤ 1.5 nF
Max. input voltage ....................................... 80 VAC pp
Sensor supply ............................................. 5...17 V
NPN / PNP input:
Trig-level LOW ............................................. ≤ 4.0 V
Trig-level HIGH ............................................ ≥ 7.0 V
Input impedance ......................................... 3.48 kΩ ± 5% || ≤ 1.5 nF
Sensor supply ............................................. 5...17 V
12
CONTENTS
5725V10 0- IN