Radio Device Test Mode; Audio Setup Mode - Tynetec Altec Response Installation Manual

7. RADIO DEVICE TEST MODE
From the Main Menu display select
Press the  key to select  Radio Test 
The display will prompt you to "Trigger the
Activate the device to be tested.
The display will show the device type, it's 8 digit ID number and Slot number.
To exit the mode select  Exit 
8. AUDIO SETUP MODE
From the Main Menu display select
Press ENTER and a message will announce "Test 1 2 3" at the current volume level.
Use the   keys to increase/decrease the speech volume level.
Press the ENTER key again to check the new level.
Press the  key to select
Use the   keys to increase/decrease the siren volume level.
Press the ENTER key to check the new level.
Press the  key to select
Scroll down past  Key Click 
Press the   keys to set the location speech message on "" or off "X".
Press the  key to select  Mute Time: 120 
Use the  keys to select each digit (0‐9) of the mute time (in seconds) and use the   keys to move between digits, then
press the ENTER key.
Press the  key to select
This will also exit the menu.
Doc No. FM0548 issue B Page 7
 Radio Devices 
and press the ENTER key.
Radio Devices
 Radio Test
Exit
Sensor".
Radio Test
Trigger Sensor :)
 Exit
then press the ENTER key.
 Audio Setup 
Audio Setup
 Speech
Siren
Key Click
 Siren 
and press the ENTER key, the siren will sound at the current volume level.
 Key Click 
then press the   keys to set on "" or off "X".
and the display will show;
Audio Setup
 Location Speech
Mute Time : 20
Apply
 Apply 
then press the ENTER key.
and press the ENTER key.
)
and press the ENTER key, the display will show;


then press the ENTER key.








