15. HOW TO CREATE NEW SENSORS
When the Altec Response left the factory it was programmed to recognise all sensors in the Altec range at that time – see list
inside front cover. If you attempt to learn a new sensor and it is not being recognised then you can add it to the Altec
Response memory using the "Create Sensor" menu option.
From the Main Menu display scroll down to Create Sensor
The display will change to show Create Sensor options;
Use the keys to select the next available EMPTY SLOT
Press the ENTER key then press the & keys together to clear the
Use the keys to enter the first character of the new device type being added, select from 0‐9 A‐Z SPACE.
Use the keys to move between characters. Press the ENTER key when done.
Press the key to select BS Code: 00
BS code and use the keys to move between digits then press the ENTER key. Note: the BS code is the first 2 digits of the
8 digit ID printed on the device label.
Press the key to select
of the BS Status 1 and use the keys to move between digits then press the ENTER key. Note: the BS Status 1 (alarm) is
normally 09.
Press the key to select BS Status 2: 00
the BS Status 2 and use the keys to move between digits then press the ENTER key. Note: the BS Status 2 is normally 00.
To exit the mode select Exit
Note: if you are unsure, please contact Tynetec's customer support department for details of the BS codes and status's for
new devices.
Doc No. FM0548 issue B Page 11
Main Menu
Load Defaults
Create Sensor
Exit
Create Sensor
Slot : 01
EMPTY SLOT
BS Code: 00
then press the ENTER key. Use the keys to select the first digit (0‐9) of the
Create Sensor
BS Status 1 : 00
BS Status 2 : 00
Exit
BS Status 1: 00
then press the ENTER key.
and press the ENTER key.
V1.00A
(max 12).
EMPTY
then press the ENTER key. Use the keys to select the first digit (0‐9)
then press the ENTER key. Use the keys to select the first digit (0‐9) of
SLOT prompt.