Navigating The Display Menus - Tynetec Altec Response Installation Manual

3. NAVIGATING THE DISPLAY MENUS
If the display is blank press the ENTER key once and the display will illuminate.
Press the ENTER key again to display the Main Menu.
Use the  keys to scroll through the options;
The black  or  arrows in the top right hand corner of the display indicate that more menu options are available by
pressing the  keys. Scroll down past
The menu option with 2
This will either take you to another sub‐menu or give you the option to edit data or text.
In edit mode the right hand side arrow will move in as shown below;
Use the  keys to select the first digit (0‐9) and the   keys to move back/forwards between digits. The same applies to
editing text (A‐Z).
To exit a menu move the arrows to
To return to the Main Menu at any time press the  &  keys together.
TEXT"
To clear "FREE
 outward pointing arrows 
If a menu option has 2
and Siren volume levels can be increased/decreased and Key Clicks can be set on "" or off "X" as shown below;
To save any changes made you must scroll down to select  Apply 
This will also exit the menu.
Doc No. FM0548 issue B Page 4
Main Menu

 System Log 
Main Menu

 inward pointing arrows 
Add/Edit Device  

 Exit 
then press the ENTER key.
SLOT" prompts press the &  keys together.
and "EMPTY
Audio Setup

V1.02A
Radio Devices
Audio Setup
System Log
and the display will show;
V1.02A
Load Defaults
Create Sensor
Exit
can be selected with the ENTER key.
Slot : 01
ID : 20044216 
Exit
then this can be changed using the   keys. For example Speech
Speech

Siren

Key Click
then press ENTER.






