13. HOW TO REASSIGN EXISTING SENSORS
If you need to reassign an existing radio sensor to another person/dwelling or simply amend its location/free text details then
follow the procedure below;
From the Main Menu display select Radio Devices
Press ENTER again and the display will prompt you to "Trigger the
Activate the device which you want to amend the details of.
The display will show the device type and it's 8 digit ID number.
If this is the device you activated use the key to select Edit
If it's NOT the device you activated press the ENTER key to select Reject
Amend the necessary details as described in section 4 of this manual.
To exit the mode press the key to select Exit
14. HOW TO SWITCH THE ALTEC RESPONSE OFF
If possible the Altec Response should be left plugged in and switched on at all times. This will ensure its battery is always fully
charged and alarm calls will always be received. If the unit must be switched off follow the procedure below;
Switch the mains supply OFF and unplug power lead.
Press the ENTER key once to illuminate the display then press ENTER again to display the Main Menu.
Press the key to select Load Defaults
Press the key to select Power Off
Press the key to change the "X" to a ""
Press the key to select Apply
The display will blank, the unit is now switched off and will not receive any alarm calls.
See section 2 of this manual for how to switch the Altec Response back on.
Doc No. FM0548 issue B Page 10
and press the ENTER key, the display show;
Radio Devices
Learn Device
Delete Device
Add/Edit Device
Learn Device
Trigger Sensor :)
Exit
Personal Pendant
Id: 20044216
Reject
Edit
then press the ENTER key.
then press ENTER.
Load Defaults
Sensor Defaults
Power Off
Apply
then press ENTER.
Sensor".
)
then press ENTER.
then try again.
X