Re-Circulating Requirements - Sirius Range Hoods SU909 Installation Instructions Manual

CAUTION: Make sure the power is turned
off at source. Make electrical connections
(refer to Figure 10). Ensure that the plastic
flaps at the exhaust outlet of the fan move
freely and have not become jammed or
stuck.
fig. 10
Connect the appropriate length of ducting to
the fan exhaust point and connect the duc-
ting to the exterior.
Do not fix the ducting to the range hood
exhaust outlet with screws: use duct
tape. Use duct tape on all joints.

Re-Circulating Requirements.

If the unit is to be used in the recirculating
mode, fit the carbon filters after the installa-
tion is completed (refer to Figure 11).
fig. 11
The carbon filter fits in behind the aluminium
grease filter. Ensure that the plastic tabs on
the carbon filter are facing outwards other-
wise it will be difficult to remove it later for
replacement.
A short length of ductwork must be con-
nected from the exhaust outlet on the fan
to wherever the air is to be exhausted.
Allow sufficient space to connect the duct-
work to the top of the exhaust outlet on the
fan housing. Do not fix the ducting to the
range hood exhaust outlet with screws, use
duct tape. Duct tape should be used on all
joints.
7