Connecting Chimneys; Re-Circulating Requirements - Sirius Range Hoods SU107 Installation Instructions Manual

Connecting Chimneys

Remove the protective covering from the
decorative chimney and carefully slide the
sections together. Do not remove the tape
strips from inside the chimney as this pro-
tects the telescoping chimney-piece from
scratching. Holding the two chimney sec-
tions together carefully position them over
the ductwork and wiring. Position the upper
chimney so that it can be fixed via the holes
on the side of the 'Y" bracket on the ceiling
(refer to Figure 11).
fig. 11

Re-Circulating Requirements.

If the unit is to be used in the re-circulating
mode, fit the carbon filter after the instal-
lation is complete fit the deflector with the
screws supplied to the upper telescope
chimney. There are holes in the back upper
edge of the decorative chimney for this pur-
pose. A short length of ducting is connected
between the exhaust outlet on the fan and
the deflector to direct the air back into the
kitchen through the vents at the top of the
upper decorative chimney.
The carbon filter (supplied separately) that
absorbs odors is installed behind the alumi-
nium grease filter (refer to Fig 14).
fig. 12
fig. 13
fig. 14
9