Operation; Normal Operation - HomeMatic HM-Sec-Key Mounting Instruction And Operating Manual

Operation

• The direction of rotation selection is shown on the display. The door lock drive is in
factory status and must be set up to the door lock again.
After installing the drive again, run a complete door lock drive setup for the
used lock.
7 Operation
Door lock drive operation is possible in three different ways:
• Device operation
• Operation via a Homematic remote control
• Operation via the Homematic Central Control Unit
The action (Lock, Unlock or Open) is shown on the display of the door lock drive. The
last method of operation is also shown.
Number/ Operation mode
letter
M Operation with the buttons on the device
1–K Operation with a Homematic remote control, the letter/number shows
the memory location of the remote control used for the operation
c Command from the Homematic Central Control Unit
Briefly pressing the button pair that has been taught-in can be used for locking and
unlocking, a longer press of the "Unlock" button can be used for opening the door.
7.1

Normal operation

7.1.1 Lock
The following describes operation on the device. The same behaviour applies for opera-
tion with a remote control and with the central control unit. but a different letter/number
is shown on the display (see previous section).
• Press the button "Lock" (F) on the door lock drive. "M" is shown on the display.
The lock bolt moves to the previously defined locking position and the symbol
"Locked" ( ) appears. Upon completion of the procedure, a long signal tone is
emitted on the door lock drive.
If the lock has been turned on the inside with the handwheel or with a key from
outside in the meantime, for safety reasons it does not move to the "Locked"
position but turns to the stop in the direction "Locked" instead.
48