Mounting The Drive; Fig. 5: Loosen The Screws Of The Wireless Door Lock Drive; Fig. 6: Base Fastener With Door Leaf - HomeMatic HM-Sec-Key Mounting Instruction And Operating Manual

A
5.3

Mounting the drive

To install the door lock drive, proceed as follows:
Loosen the screws (A) for the base fastener (S) (see fig. 6) on the left and right of
•
the door lock drive with the Allen key supplied.
A
Fig. 5: Loosen the screws of the wireless door lock drive
• Remove the base fastener (S) from the door lock drive.
• Make sure that the nuts remain in the base fastener.
• Put the base fastener on the protruding part of the lock cylinder (door leaf (R)). If
necessary, slightly loosen the two screws of the base fastener (I) (see fig. 7).
Fig. 6: Base fastener with door leaf
Fasten the base fastener with the screw (I) on top and bottom on the lock cylinder. In
certain cases, the base fastener can also be fastened to the door with two wood-screws
(J).
K
A
A
R
S
R
S
Mounting
35