Fig. 11: Screenshot Teach-In Devices - HomeMatic HM-Sec-Key Mounting Instruction And Operating Manual

6.3.3 Teaching-in to the Homematic Central Control Unit
Please read this entire section before starting the teach-in procedure!
Your device can be conveniently
• controlled and configured,
• connected directly to other devices or
• used in central control unit programs
by using the Homematic software "WebUI". Therefore, your door lock actuator has to be
taught-in to the Homematic Central Control Unit first. New devices are taught-in to the
central control unit via the Homematic „WebUI".
As soon as a device has been taught-in to a central control unit, it can only be
connected to other components via this unit.
Each device can be taught-in to one central control unit only.
During teach-in, please make sure you maintain a distance of at least 50 cm
between the Homematic devices and the central control unit.
To teach-in your device to the central control unit, proceed as follows:
• Open the "WebUI" user interface in your browser.
• Click the "Teach-in devices" button on the right-hand side of the screen.
Fig. 11: Screenshot teach-in devices
• To activate teach-in mode, click "Start teach-in mode".
Start-up
45