Fig. 12: Screenshot Start Teach-In Mode - HomeMatic HM-Sec-Key Mounting Instruction And Operating Manual

Start-up
Fig. 12: Screenshot start teach-in mode
• Teach-in mode remains activated for 60 seconds. An information box shows how
much teach-in time remains.
• Meanwhile, activate the teach-in mode of the door lock drive to teach-in as well.
Press the top button "Unlock" (D) for approx. 2 seconds, to activate teach-in mode.
After a short time, the newly taught-in device will appear in the inbox of your software
interface. The button „Inbox (x new devices)" indicates how many new devices have
been taught-in successfully.
• If required, you can teach-in additional devices by repeating the steps described
above for each device.
• Now configure the newly taught-in devices in the inbox as described in section „Con-
figuring newly taught-in devices".
6.3.4 Configuring newly taught-in devices
Once you have taught-in your door lock drive to the Homematic Central Control Unit,
it will be moved to the inbox. Here, you must configure the device and its associated
channels in order to make them available for operating and configuration tasks. Give
the device a name and assign it to a room. You can also make individual parameter set-
tings.
Now you can use the „WebUI" user interface to control your device, configure it, connect
it directly to other devices, or use it in central control unit programs. Please refer to the
Homematic WebUI Manual for more details (you can find this in the „Downloads" area of
the website www.homematic.com).
46