Teaching-In - HomeMatic HM-Sec-Key Mounting Instruction And Operating Manual

Start-up
6.3

Teaching-in

Read this section entirely before starting to teach-in the device!
To integrate the door lock drive into your Homematic system and enable communication
with other Homematic devices (e.g. a Homematic Remote Control 4 buttons, KeyMatic),
the device has to be taught-in first. You can teach-in the device to other Homematic de-
vices (see sec. „6.3.1 Teaching-in remote controls and buttons" on page 42) or to the
Homematic Central Control Unit (see sec. „6.3.3 Teaching-in to the Homematic Central
Control Unit" on page 45).
6.3.1 Teaching-in remote controls and buttons
The first remote control that is taught-in is automatically defined as "Master"
remote control. Memory location "1" is reserved for this. This is required in
order to authenticate other teach-in procedures (from other buttons/button pairs
as well for the master remote control)!
Teach-in the first button pair of the Master remote control:
To teach-in a button pair to your door lock drive, proceed as follows:
• Press the top button "Unlock" (D) for approx. 2 seconds, to start the teach-in procedure.
The display will show memory location "1". The symbols for radio reception and
"Unlock" flash; the door lock drive is ready for teaching-in.
Teach-in mode is ended automatically after teaching-in is successful, after
actuating any button on the drive or after 20 seconds without entry. A beep is
then emitted and "M" is shown on the display.
• Activate configuration mode of the remote control you wish to teach-in to the door
lock drive and briefly press one of the buttons of the button pair or respective button
to be taught-in. Please refer to the operating manual of the device you wish to teach-
in for further information on activating the teach-in mode.
Briefly pressing the button pair that has now been taught-in can be used for locking and
unlocking, a longer press of the "Unlock" button can be used for opening the door. This
first taught-in button pair is for authenticating further teach-in procedures.
Teaching-in an additional remote control/button pair
To teach-in an additional remote control or button pair to your door lock drive, proceed
as follows:
• Press the top button "Unlock" (D) for approx. 2 seconds, to start the teach-in procedure.
42