Remote Control - T+A MP 3100 HV User Manual

14

Remote control

General
All the MP 3100 HV mechanism control functions and auxiliary functions can be
operated using the remote control system.
In general terms the remote control buttons have the same function as the
corresponding buttons on the MP 3100 HV front panel.
Because the FD100 remote control works with radio frequency signals it is
necessary to connect a RF antenna to the "FD100 Remote ANT" socket on the
back panel of the MP 3100 HV (see the connection diagram in appendix A). If the
remote control is used for the first time, it is necessary to carry out the pairing
procedure between the FD100 and the MP 3100 HV (see chapter 'Pairing the
FD100 radio remote control')
The following tables show the remote control buttons and their function when
operating the machine.

The FD100 remote control is no multi room remote control. Its maximum
operating distance under normal conditions is about 12 meters. Obstacles like
walls or furniture can decrease the operating distance. The aerial should be set
up free-standing using the magnetic base supplied in the set; this ensures
maximum possible range.



Switches the MP 3100 HV on and off
(red)

Opens the Source Select list.
Use the  /  buttons to select the source of your
(yellow)
choice, then confirm by pressing the  button.

Direct alpha-numeric input, e.g. track number, quick station
select, radio station

Special characters are also assigned to the  and 
abc
... buttons.

During the text input process it is possible to switch between
xyz numerical and alpha-numeric input, and between capital and
lower-case letters, using the  button.


Switches the loudspeaker outputs of an amplifier connected via H-
Link bus ON and OFF. (MUTING). (e.g. PA 3000 HV)
(yellow)
-  +
Decrease / increase the volume of an amplifier connected via H-
Link bus
(yellow)

Opens the Tone- / Balance- Control menu of an amplifier
connected via H-Link bus.

Opens the System Configuration menu of the MP 3100 HV.

A long press is used to switch between two different front panel
display modes. (Not available for all sources!)