T+A MP 3100 HV User Manual page 64

CD playback stops
'jumps'.
Streaming Client
The streaming client cannot
connect to a network.
On the display the
indication
'Cannot connect to...'
is displayed.
Transmission interruptions
occur when listening to
internet radio stations.
Some internet radio stations
cannot be received
64
or Cause 1:
CD damaged or dirty.
Remedy:
Clean CD. A damaged CD cannot be repaired!
Cause 2:
The CD uses a copy protection system which does not conform to the CD-
Audio standard (Red Book Standard)
Remedy:
Take back the CD to the dealer and ask for a proper CD according to the
general CD standard.
Cause 1 (cable LAN):
Network cable not properly connected
Remedy:
Connect network cable, check connection to router
Cause 2 (wireless LAN):
WLAN reception quality bad (low field strength). Possibly too much attenuated
by walls/ceilings on the transmission path.
Remedy:
Optimize location of receiver and transmitter antennas.
Alternative:
If transmission problems persist a so called ‚Power Line' network might be
good alternative to establish a good and stable network connection.
The best, safest and most secure network however will always be a cable LAN
network.
Cause 3:
Network parameters not properly configured.
Remedy:
Configure the
configuration').
Cause 1:
The capacity of the internet radio station's server is at its limit.
Remedy:
Choose a different station.
Cause 2:
Network problems occurred.
Remedy:
Check your network (see above).
Cause:
The internet radio station has been switched off, it transmits only at certain
hours of the day or it has changed its internet address.
Remedy:
Try to get information from the website of the station regarding transmission
hours and internet address (URL).
Try to establish a connection to the station at a later time.
network parameters correctly (see chapter 'Network