The Configuration For A Wlan Connection; Setting The Parameters For A Wireless Network; Searching For And Selecting The Network; Entering The Password (For Encoded Networks) - T+A MP 3100 HV User Manual

The Configuration for a WLAN connection

Setting the parameters for a
wireless network
Searching for and Selecting
the Network
Entering the Password (for
encoded networks)
Storing Network Settings
and Restarting
 Check that there is no cable connected to the LAN socket of the
MP 3100 HV.
 Connect one of the WLAN aerials from the accessories enclosed to the
WLAN socket.
 Switch the MP 3100 HV on, open the System Configuration menu by pressing
the  button on the remote control handset or the  button on the front
panel of the MP 3100 HV.
 Use the  /  buttons on the remote control handset to select the
menu point "Network", then confirm your choice with the  button.
 The following menu now opens:

First select the menu point "Scan for WLANS", and activate it by
pressing the  button.

A list of the WLANs found is displayed on the screen.

Use the  /  buttons to select the WLAN to which you
wish the MP 3100 HV to be connected, and confirm your choice with
the  button.
If the network is encoded, the window shown below will appear once the WLAN
is selected.

At this point please enter the network password and confirm your input
by pressing .
Select the "Store and exit?" point, and confirm your choice with .
Finally select the "Store and exit?" menu point and press the  button to
accept the settings.

If a WEP code is used, the password must be entered as a hexadecimal code
(0 - 9, A - F).
Possible entries
55