Oil Change - GENERGY 2013022 Instructions For Use Manual

10.1 Oil change.

1 Keep the engine running during 5 to 10 minutes for the oil to reach some
temperature and reduce its viscosity (more liquid). This way it will be easier to
extract it completely.
2 Place an appropriate container under the oil draining hole to collect the used oil.
3 Unscrew the oil draining screw by turning counter clockwise, keep the screw
and its joint.
4 Release the oil filling plug so the engine cans intake air and achieve faster
draining.
5 Turn the engine by pulling the starter rope gently, causing most of the oil lodged
in the moving parts of the engine to fall.
OIL FILLING PLUG
OIL DRAINING
HOLE
5 Once all of the oil has been extracted, place the draining screw again with its
joint and clean oil spillage, if any.
6 Refill with the recommended oil to the maximum level, without exceeding it. If
the machine is leveled, the oil should not exceed the level. (Check point 4.3 of this
manual for the type of oil).
OIL DRAINING SCREW
32