Sony CYBER-SHOT dsc-s75 Operating Instructions Manual page 88

--."... ."--
.I"_.... ~
~rn~~orn
1 Cause andfor solution
The image does not
l
The video output signal setting of your camera is
appear on the TV screen.
incorrect.
-Change the settmg (page 77).
A file error occurs when
l
The image size IS larger than 2048x1536.
you play back a tile.
+Use an image size of 2048x1536 or smaller.
The picture is
l
The camera is set to TEXT mode.
monochrome (black and
white).
+Cancel TEXT mode (page 55).
l
P. EFFECT IS set to B&W mode.
+Cancel B&W mode (page 61).
The lens does not retract
l
The battery 1s discharged.
even when the power is
turned off.
+Replace it with a fully charged battery or use the
AC power adaptor.
Your personal computer
l
The battery level is low.
does not recogmze your
+Use the AC power adaptor (page 14).
camera.
l
The camera is turned off.
+Tum on the camera.
l
The USB cable is not connected firmly.
+Disconnect the USB cable, and connect it agam
firmly. Make sure that "USB MODE" is
displayed on the LCD screen (pages 33,35).
l
The USB connectors on your personal computer are
connected to other equipment besides the keyboard,
the mouse, and your camera.
+Disconnect the USB cables except for the ones
connected to the keyboard, the mouse, and your
camera.
l
The USB driver is not mstalled.
*Install the USB driver (page 33).
l
lJJSB CONNFCIJ is set to m] m the setup setnngs.
-Get it to [NORMAL] (page 77).
l
Since the camera is connected to a computer with
the USB cable before mstalling the USB driver, the
drive is not recognized by the computer.
*Delete the drtve which IS not recogmzed, then
install the USB driver. For details, see the
procedure on page 88.
Vo function works though
.he power is on.
+Remove the battery pack, then install it agam
after about one mmute. If the function still do
not work, press the reset button located on the
bottom using a sharp-pointed obJect. (If you
press the reset button, the date and time setting
is cleared.)
87