Adding Physical Interfaces To An Irf Port - HP FlexFabric 12900 Series Configuration Manual

A change to member priority can affect the master re-election result. However, it does not cause an
immediate master re-election.
To change the priority of a member device:
Step
1. Enter system view.
2. Specify a priority for a
member of an IRF fabric.

Adding physical interfaces to an IRF port

An IRF port can have a maximum of eight physical interfaces.
In IRF mode, you can add physical interfaces to an IRF port without traffic interruption on the IRF port.
When you perform this task, follow the IRF physical interface restrictions and configuration guidelines in
these sections:
IRF physical interface
•
• Binding physical interfaces to IRF
To configure IRF ports:
Step
1. Enter system view.
2. Enter Ethernet interface view
or interface range view.
3. Shut down the interface or
interfaces.
4. Return to system view.
5. Enter IRF port view.
Command
system-view
irf member member-id priority priority
requirements.
ports.
Command
system-view
•
Enter interface range view:
Method 1:
interface range { interface-type
interface-number [ to
interface-type
interface-number ] } &<1-5>
Method 2:
interface range name name
[ interface { interface-type
interface-number [ to
interface-type
interface-number ] } &<1-5> ]
•
Enter interface view:
interface interface-type
interface-number
shutdown
quit
irf-port member-id/port-number
21
Remarks
N/A
The default IRF member priority
is 1.
Remarks
N/A
To shut down a range of IRF
physical interfaces, enter
interface range view.
To shut down one IRF physical
interface, enter its interface
view.
If the system does not allow you
to shut down a physical
interface, follow the system
instruction to shut down its peer
interface.
N/A
N/A